ICM : Aqua-Check : Water Analyzer Specifications

Aqua Quest : Water Analyzer

AQUAQUEST: Rental Program for 2006 Click Here for More Details

Aqua Quest : Water Analyzer Specifications

SENSOR	UNIT	RANGE	RESOLUTION	ACCURACY	COMPENSATION
pH	pH	1-13	.01	.02	Temperature/None
ORP	mV	+/- 500mV	1mV	+/- 2%	None

SENSOR	UNIT	RANGE	RESOLUTION	ACCURACY	COMPENSATION
Temperature	^{^oC}	0-50^oC	.1^o	1^o	None
	^{^oF}	32-122^oF	.1^o	1.8^o	None

SENSOR	UNIT	RANGE	RESOLUTION	ACCURACY	COMPENSATION
Conductivity	Siemans	10-99.9猶	.1猶	+/- 3%¹	Temperature/None
		100-999.9猶	1猶	+/- 3%	Temperature/None
		1-9.99mS	.01mS	+/- 3%	Temperature/None
		10-99.9mS	.1mS	+/- 3%	Temperature/None
	TDS	5-49.8ppm	.1ppm	+/- 3%²	Temperature/None
		50-498ppm	1ppm	+/- 3%	Temperature/None
		.5-4.98ppk	.01ppk	+/- 3%	Temperature/None
		5-49.8ppk	.1ppk	+/- 3%	Temperature/None

SENSOR	UNIT	RANGE	RESOLUTION	ACCURACY	COMPENSATION
Oxygen	ppm	0.0-20.0ppm	.1ppm	+/- 2-5%³	Temperature/None/Salinity
	mg/L	0.0-20.0mg/L	.1mg/L	+/- 2-5%³	Temperature/None/Salinity
	%SAT	0.0-150.0%	.1%	+/- 2-5%³	Temperature/None/Salinity/Barometric

SENSOR	UNIT	RANGE	RESOLUTION	ACCURACY	COMPENSATION
Barometer⁴	mm Hg	400-1000mmHg	1mmHg	+/- 5%	None
	In. Hg	15.8-39.3inHg	.1inHg	+/- 5%	None

Serial Baud Rates:	9600
PC Requirements:	Pentium 90MHz or better. 10M of hard drive space. VGA monitor 3.5 floppy drive.
Battery Indicator:	A display will show the operator how much battery time is left on the unit.
Sensors:	3 replaceable sensors
Battery:	6 Volt rechargeable Sealed Lead Acid
Usage Time:	8 hrs. Or with the additional battery 16hrs. Low battery indicator for 1hrs. Of usage left.
Recharge Time:	15 hrs. Can be charged and use at the same time.
Display:	4 X 16 LCD
Operating Temperature:	0-40^oC (Meter)
	0-50^oC (Probe)
Storage Temperature:	-5-60^oC (Meter/Probe)
Probe Dimensions	15" L x 3 3/4"D
Meter Dimensions	204mm L x 110mm W x 41mm H
Shipping Weight:	25 lbs.

Note:

¹Minimum signal is 10痠hos or 10猶

²Minimum signal is 5ppm

³+/-2% within 5^oC calibration temperature, +/- 5% from 0-35^oC

⁴For meters with factory installed pressure sensors. Meter without barometer sensor will still make the necessary compensation but must be entered manually.